Additionally, it created a rather expensive repair bill for a Queens NY homeowner.Īs you tighten the reamer, the conical point will flare the copper easily. The end result was the copper literally slipping right out the flare fitting, and causing a flood in the roadway. This photo below is a Balkan water main repair job required because a previous contractor connected the copper without flaring it. The affect of not flaring copper properly are potentially unnecessary and costly repairs. Many copper cutting tools also contain a cleaning edger. After the tubing is cut, you may have to clean off loose pieces of left over copper. You need to have strong grip on the pipe to make precise cuts, gently tightening the tool every turn or so. Because you have to rotate the tool during the process, such tool is best used when you have to cut a pipe that is only a little longer than you need. When you rotate the tool around the copper, the blade gradually cuts the tubing and leaves a clean edge. It typically has a cutting blade, guide wheel, and knob for tightening. A cutting tool circles around the pipe, making for a nice clean cut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |